Rohde & Schwarz RTP Series - Page 2135

Remote control commands
R&S
®
RTP
2135User Manual 1337.9952.02 ─ 12
TRIGger<m>:PCIE:DLLP:VPAT <VendorBtPatt>
Sets the vendor pattern to be triggered on for the data link layer trigger.
Parameters:
<VendorBtPatt> 24-bit pattern, see Chapter 22.4.6, "Bit pattern parameter",
on page 1148. The string parameter accepts the bit value X
(don't care).
TRIGger<m>:PCIE:ERRC:CRC <CRC16>
Enables triggering on 16-bit cyclic redundancy check (CRC) errors.
Parameters:
<CRC16> ON | OFF
*RST: OFF
TRIGger<m>:PCIE:ERRC:DISP
<Disparity>
Enables triggering on disparity errors.
Parameters:
<Disparity> ON | OFF
*RST: OFF
TRIGger<m>:PCIE:ERRC:ECRC <ECRC>
Enables triggering on end-to-end cyclic redundancy checksum (ECRC) errors.
Parameters:
<ECRC> ON | OFF
*RST: OFF
TRIGger<m>:PCIE:ERRC:INVP <InvalidSymbol>
Enables triggering on invalid symbol errors.
Parameters:
<InvalidSymbol> ON | OFF
*RST: OFF
TRIGger<m>:PCIE:ERRC:LCRC <LCRC>
Enables triggering on link cyclic redundancy check (LCRC) errors.
Parameters:
<LCRC> ON | OFF
*RST: OFF
Protocols