Rohde & Schwarz RTP Series - Page 2138

Remote control commands
R&S
®
RTP
2138User Manual 1337.9952.02 ─ 12
TRIGger<m>:PCIE:TLP:CPLS <CplStatus>
Sets the completion status to be triggered on for the transaction layer type trigger.
Parameters:
<CplStatus> ANY | SUCCESS | UNSUPPORTED | RETRY | ABORT
*RST: ANY
TRIGger<m>:PCIE:TLP:DEID <TLPDeviceID>
Sets the device ID to be triggered on for the transaction layer type trigger.
Parameters:
<TLPDeviceID> 16-bit pattern, see Chapter 22.4.6, "Bit pattern parameter",
on page 1148. The string parameter accepts the bit value X
(don't care).
TRIGger<m>:PCIE:TLP:MERW <MemRW>
Sets the read/ write type to be triggered on for the transaction layer type trigger.
Parameters:
<MemRW> ANY | READ | WRITE
*RST: ANY
TRIGger<m>:PCIE:TLP:MSGC <TLPMessageCode>
Sets the message code to be triggered on for the transaction layer type trigger.
Parameters:
<TLPMessageCode> 8-bit pattern, see Chapter 22.4.6, "Bit pattern parameter",
on page 1148. The string parameter accepts the bit value X
(don't care).
TRIGger<m>:PCIE:TLP:MSGR <MsgRouting>
Sets the message routing type to be triggered on for the transaction layer type trigger.
Parameters:
<MsgRouting> ANY | ROOTCOMPLEX | ADDRESS | DEVICEID | DEViceid |
BROADCAST | LOCAL | GATHERED
DEVICEID = DEViceid
*RST: ANY
TRIGger<m>:PCIE:TLP:ORDE <Ordering>
Sets the ordering type to be triggered on for the transaction layer type trigger.
Protocols