Rohde & Schwarz RTP Series - Page 2153

Remote control commands
R&S
®
RTP
2153User Manual 1337.9952.02 ─ 12
Parameters:
<ResetVHGroup> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN | EIGHT | NINE | TEN | ELEVEN | TWELVE |
THIRTEEN | FOURTEEN | FIFTEEN
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:DLLP:MULT:VLNR <SearchName>,<VirtualLink>
SEARch:TRIGger:PCIE:DLLP:MULT:VLNR? <SearchName>
Sets the virtual link (VL) number to be searched for, for the data link layer.
Parameters:
<VirtualLink> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:DLLP:POWM <SearchName>,<PowerMngtType>
SEARch:TRIGger:PCIE:DLLP:POWM? <SearchName>
Sets the power management type to be searched for, for the data link layer.
Parameters:
<PowerMngtType> ANY | ENTERL1 | ENTERL23 | ACTREQL1 | REQUESTACK
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:DLLP:SEQ <SearchName>,<ACKNAKSequence>
SEARch:TRIGger:PCIE:DLLP:SEQ? <SearchName>
Sets the sequence field, indicating what TLPs are affected by the ACK/NAK, to be
searched for, for the data link layer.
Parameters:
<ACKNAKSequence>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:DLLP:TYPE <SearchName>,<Type>
SEARch:TRIGger:PCIE:DLLP:TYPE? <SearchName>
Sets the DLLP t type to be searched for, for the data link layer.
Protocols