Rohde & Schwarz RTP Series - Page 2154

Remote control commands
R&S
®
RTP
2154User Manual 1337.9952.02 ─ 12
Parameters:
<Type> ANY | MRDLLP | ACK | NAK | INITFC1 | INITFC2 | UPDATEFC |
PM | VENDOR
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:DLLP:VPAT <SearchName>,<VendorBtPatt>
SEARch:TRIGger:PCIE:DLLP:VPAT? <SearchName>
Sets the vendor pattern to be searched for, for the data link layer.
Parameters:
<VendorBtPatt> 24-bit pattern, see Chapter 22.4.6, "Bit pattern parameter",
on page 1148. The string parameter accepts the bit value X
(don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:ERRC:CRC <SearchName>,<CRC16>
SEARch:TRIGger:PCIE:ERRC:CRC? <SearchName>
Enables searching for 16-bit cyclic redundancy check (CRC) errors.
Parameters:
<CRC16> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:ERRC:DISP <SearchName>,<Disparity>
SEARch:TRIGger:PCIE:ERRC:DISP? <SearchName>
Enables searching for disparity errors.
Parameters:
<Disparity> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:PCIE:ERRC:ECRC <SearchName>,<ECRC>
SEARch:TRIGger:PCIE:ERRC:ECRC? <SearchName>
Enables searching for end-to-end cyclic redundancy checksum (ECRC) errors.
Protocols