Rohde & Schwarz RTP Series - Page 2171

Remote control commands
R&S
®
RTP
2171User Manual 1337.9952.02 ─ 12
Parameters:
<StrobeSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
*RST: C2W1
Usage: Asynchronous command
BUS<m>:DDR:STRBe:THReshold <StrobeThreshold>
Sets the threshold value for the digitization of the strobe line.
Suffix:
<m>
.
1..4
Parameters:
<StrobeThreshold> Range: -10 to 10
Increment: 0.01
*RST: 0
Default unit: V
Usage: Asynchronous command
BUS<m>:DDR:BITRate <Bitrate>
Declares the nominal bit rate of the data signal for the DDR eye diagram analysis.
Suffix:
<m>
.
1..4
Parameters:
<Bitrate> Range: 1000 to 10E+9
Increment: 100E+3
*RST: 800E+6
Default unit: bps
Usage: Asynchronous command
22.17.24.2 Decode results
In all BUS<m>:DDR:RESult:FRAMe<n> commands, the suffix <m> selects the serial
bus and the suffix <n> selects the frame number in the decode table.
BUS<m>:DDR:RESult:FCOunt?.................................................................................... 2172
BUS<m>:DDR:RESult:FRAMe<n>:FLD<o>:FVAL?..........................................................2172
BUS<m>:DDR:RESult:FRAMe<n>:FLD<o>:STARt?........................................................ 2172
BUS<m>:DDR:RESult:FRAMe<n>:FLD<o>:STATus?...................................................... 2173
BUS<m>:DDR:RESult:FRAMe<n>:FLD<o>:STOP?.........................................................2173
BUS<m>:DDR:RESult:FRAMe<n>:FLD<o>:VAL?............................................................2173
BUS<m>:DDR:RESult:FRAMe<n>:NWRDs?.................................................................. 2174
BUS<m>:DDR:RESult:FRAMe<n>:STARt?.....................................................................2174
Protocols