Rohde & Schwarz RTP Series - Page 2189

Remote control commands
R&S
®
RTP
2189User Manual 1337.9952.02 ─ 12
EYE<m>:QUALify:GATE[:STATe] <State>
Enables the gate.
Suffix:
<m>
.
1..4
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
EYE<m>:QUALify:GATE:COUPling
<CouplingMode>
Sets the gate coupling. To use cursor lines or zoom areas as gate limits, the cursor or
zoom must be defined before.
Suffix:
<m>
.
1..4
Parameters:
<CouplingMode> NONE | CURSor | ZOOM
*RST: NONE
Usage: Asynchronous command
EYE<m>:QUALify:GATE:MODE <Mode>
Defines whether the gate limit is defined in absolute or relative values when no gate
coupling is set.
Suffix:
<m>
.
1..4
Parameters:
<Mode> ABS | REL
*RST: ABS
Usage: Asynchronous command
EYE<m>:QUALify:GATE:ABSolute:STARt <Start>
EYE<m>:QUALify:GATE:ABSolute:STOP <Stop>
Set the absolute time values for gate start and gate end.
Suffix:
<m>
.
1..4
Parameters:
<Start>, <Stop> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Protocols