Rohde & Schwarz RTP Series - Page 2188

Remote control commands
R&S
®
RTP
2188User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..4
Parameters:
<PositionUI> Range: -100E+9 to 100E+9
Increment: 0.01
*RST: 0.5
Usage: Asynchronous command
Display
EYE<m>:MSLices <MaxSliceCount>
Sets the number of waveform slices for a single acquisition.
Suffix:
<m>
.
1..4
Parameters:
<MaxSliceCount> Range: 1 to 1000000
Increment: 1
*RST: 2000
Usage: Asynchronous command
EYE<m>:DISPlay[:MODE] <EyestripeMode>
Defines when the eye stripe is shown: always, never, or during mask tests.
Suffix:
<m>
.
1..4
Parameters:
<EyestripeMode> ALWays | MTONly | NEVer
MTONly: Mask test only
*RST: MTONly
Usage: Asynchronous command
Qualify: gate settings
EYE<m>:QUALify:GATE[:STATe]...................................................................................2189
EYE<m>:QUALify:GATE:COUPling................................................................................2189
EYE<m>:QUALify:GATE:MODE.................................................................................... 2189
EYE<m>:QUALify:GATE:ABSolute:STARt...................................................................... 2189
EYE<m>:QUALify:GATE:ABSolute:STOP.......................................................................2189
EYE<m>:QUALify:GATE:RELative:STARt.......................................................................2190
EYE<m>:QUALify:GATE:RELative:STOP....................................................................... 2190
EYE<m>:QUALify:GATE:CURSor..................................................................................2190
EYE<m>:QUALify:GATE:ZDIagram................................................................................2191
Protocols