Rohde & Schwarz RTP Series - Page 2191

Remote control commands
R&S
®
RTP
2191User Manual 1337.9952.02 ─ 12
EYE<m>:QUALify:GATE:ZDIagram <ZoomDiagram>
Selects the zoom diagram to be used for eye gating. The zoom area is is used as gate.
Suffix:
<m>
.
1..4
Parameters:
<ZoomDiagram> String with the name of the zoom diagram
Example: Gate definition for eye diagram 2 with zoom coupling:
EYE2:QUALify:GATE:COUPling ZOOM
EYE2:QUALify:GATE:ZDIagram "Zoom1"
Usage: Asynchronous command
Qualify: signal settings
EYE<m>:QUALify:SIGNal[:STATe].................................................................................2191
EYE<m>:QUALify:SIGNal:SOURce............................................................................... 2191
EYE<m>:QUALify:SIGNal:CONDition.............................................................................2191
EYE<m>:QUALify:SIGNal:LSELect................................................................................2192
EYE<m>:QUALify:SIGNal[:STATe] <State>
Enables the waveform-based qualification for the eye generation.
Suffix:
<m>
.
1..4
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
EYE<m>:QUALify:SIGNal:SOURce <Source>
Selects the waveform to be compared.
Suffix:
<m>
.
1..4
Parameters:
<Source> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
Usage: Asynchronous command
EYE<m>:QUALify:SIGNal:CONDition <Condition>
Selects the comparison condition: the waveform level must be greater or less than the
threshold.
Protocols