Rohde & Schwarz RTP Series - Page 2263

Remote control commands
R&S
®
RTP
2263User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..2
Parameters:
<MethodType> SW1 | SW2
*RST: SW1
ADVJitter<m>:SIGNal:REFSource <SourceType>
Selects if an explicit clock or a CDR signal is used as a reference signal.
Suffix:
<m>
.
1..2
Parameters:
<SourceType> CDR | CLOCk
*RST: CDR
ADVJitter<m>:SIGNal:CLKSource <SourceType>
Selects the reference source for the clock signal, if ADVJitter<m>:SIGNal:
REFSource is set to CLOCk.
Suffix:
<m>
.
1..2
Parameters:
<SourceType> C1W1 | C1W2 | C1W3 | C2W1 | C2W2 | C2W3 | C3W1 | C3W2 |
C3W3 | C4W1 | C4W2 | C4W3 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | DIFF1 | DIFF2 | COMMON1 |
COMMON2
ADVJitter<m>:SIGNal:EDGE <EdgeType>
The clock edge sets the point in time when the state of the data signal is checked.
Suffix:
<m>
.
1..2
Parameters:
<EdgeType> POSitive | NEGative | EITHer
*RST: EITHer
ADVJitter<m>:SIGNal:CLEStimation
Executes an estimation of the signal for the clock frequency.
Suffix:
<m>
.
1..2
Usage: Event
Asynchronous command
Jitter analysis and clock data recovery