Rohde & Schwarz RTP Series - Page 443

Mask testing
R&S
®
RTP
443User Manual 1337.9952.02 ─ 12
To move a segment on the touch screen
1. Drag&drop the segment to the new position.
2. Tap outside the mask to deselect the mask segment.
To move a point on the touch screen
1. Tap the mask segment that you want to change.
2. Drag&drop the point to the new position.
3. Tap outside the mask to deselect the mask segment.
To change the mask definition numerically
The settings mentioned here are described in detail in Chapter 10.2.2, "Mask defini-
tion", on page 428.
1. Open [App Cockpit] > "Analysis" tab > "Mask" > "Define Mask".
2. At the top, select the mask test for which you want to change the mask definition.
3. To add or delete a mask segment, tap "Setup mask".
Tap the segment's row in the "User Mask: Segments" table and tap the required
button below:
● "Insert": to add a new segment before the selected segment.
● "Append": to add a new segment at the end of the list.
● "Remove": to delete the selected mask segment from the list.
4. To add, delete, or move a point of a segment:
a) Select the segment in the "User Mask: Segments" table.
b) Tap "Configure".
c) Select the point in the "Definition of segment" table.
Working with masks