Rohde & Schwarz RTP Series - Page 453

Search functions
R&S
®
RTP
453User Manual 1337.9952.02 ─ 12
11.2.2.2 Glitch
The glitch search works the same way as the glitch trigger. To apply the trigger settings
to search, tap Copy from trigger A'.
The glitch search is not available if the search source is a digital channel.
Polarity, Range, Width
See trigger settings:
●
"Range" on page 218
●
"Width" on page 218
●
"Polarity" on page 218
Remote command:
SEARch:TRIGger:GLITch:POLarity on page 1485
SEARch:TRIGger:GLITch:RANGe on page 1486
SEARch:TRIGger:GLITch:WIDTh on page 1486
Level
Sets the voltage level for trigger search. The value is used for all search event types
that require one trigger level. The search trigger level is search-specific, you can define
different levels in different searches for the same event.
Remote command:
SEARch:TRIGger:LEVel[:VALue] on page 1484
11.2.2.3 Width
The width search works the same way as the width trigger. To apply the trigger settings
to search, tap Copy from trigger A'.
Search setup