Rohde & Schwarz RTP Series - Page 550

Protocol analysis
R&S
®
RTP
550User Manual 1337.9952.02 ─ 12
Autoset
Starts software algorithms for determining the signal threshold levels and bitrate.
Remote command:
BUS<m>:FAUToset on page 1549
Bit order
Defines if a word starts with msb (most significant bit) or lsb (least significant bit). The
display of the decoded signal considers this setting, results are displayed in the speci-
fied order.
Packets
Allows you to define packets of several words in the data stream.
"None"
Packets are not considered.
"End word"
Defines a pattern as end condition of a packet, for example, a
reserved word like CR or LF. The bit pattern editor provides frequently
used values in the "Predefined values" list below the pattern table.
A new packet starts with the first start bit after the defined end pat-
tern.
"Timeout"
Defines a timeout between a stop bit and the next start bit. Enter the
minimum time that marks the end of a packet.
A new packet starts with the first start bit after the timeout.
Remote command:
BUS<m>:UART:PACKets on page 1609
BUS<m>:UART:TOUT on page 1610
BUS<m>:UART:EWORd on page 1610
UART/RS-232/RS-422/RS-485 (option R&S
RTP-K2)