Getting started
R&S
®
RTP
57User Manual 1337.9952.02 ─ 12
[Trigger]
Opens and closes the "Trigger" dialog box, where you can:
●
Select a trigger type and configure it.
●
Set general trigger parameters and control the acquisition run.
●
Qualify the trigger event with logic patterns.
●
Configure a sequence of subsequent trigger events.
●
Set up the zone trigger if option R&S RTP-K19 is installed.
[Levels]
The rotary knob sets the trigger level for all trigger types. Turn clockwise to move up
the trigger level. If the selected trigger type requires two trigger levels - upper and
lower level - press the knob to toggle between the two levels.
[Source]
Opens a dialog box where you can select the trigger source. Press the key again to
switch the source. The key lights up in the color of the selected trigger source.
[Slope]
Toggles the trigger slope or trigger polarity, dependent on the trigger type. The current
setting is shown on the trigger label, which is in the upper part of the signal bar.
[Mode]
Toggles the trigger mode between Auto and Normal. The current setting is shown on
the trigger label.
[Run Stop]
Starts and stops the continuous acquisition. A green light indicates a running acquisi-
tion. A red light shows that acquisition is stopped.
Instrument tour
To Next Page
Loading...
