Getting started
R&S
®
RTP
58User Manual 1337.9952.02 ─ 12
[Single]
Starts a defined number of acquisitions. A green light indicates a running acquisition. A
red light shows that acquisition is stopped. Press the key again to stop running acquisi-
tions.
To set the number of acquisitions, press the [Trigger] key, select the "Ctrl/Action" tab,
and set "Average count (N-single count)".
3.2.3.6 Analysis keys
The keys in the Analysis functional block provide direct access to measurement and
analyzing functions. If you press [Cursor], [Zoom] or [Meas], the action starts on first
keypress, and a second keypress opens the corresponding dialog box. If you press
another function key, the dialog box opens.
[Cursor]
Displays vertical and horizontal cursors in the active diagram and opens the "Cursor
Results" box.
Cursors are markers which are placed at points of interest on a waveform. The instru-
ment measures the cursor positions and delta values between parallel cursors.
If you press the key while a cursor measurement is enabled, the "Cursors" dialog box
opens.
In the "Cursors" dialog box, you can:
●
Configure up to 4 cursor sets
●
Define style and labels of the cursors
●
Connect the cursor to the waveform and couple the cursors
[Meas]
Starts the default automatic measurement for the active waveform and opens the
"Measurement" result box.
If you press the [Meas] key while a measurement is enabled, the "Measurements" dia-
log box is displayed, where you can:
●
Configure amplitude and time measurements, eye, spectrum, and histogram mea-
surements
●
Configure gated measurement
●
Configure long term and statistic measurements
●
Configure actions to be executed if specified limits are exceeded
Instrument tour
To Next Page
Loading...
