Protocol analysis
R&S
®
RTP
724User Manual 1337.9952.02 ─ 12
●
Index
●
CRC
This control frame is used mainly for power mode change and L1.5 link management.
It is also used in scrambling request.
Trigger Upr0 ← Type
Triggers on a UniPro Trigger Upper0 frame. This control frame is used for link startup
sequence.
Trigger Upr1 ← Type
Triggers on a UniPro Trigger Upper1 frame. This control frame is used for link startup
sequence.
Trigger Upr2 ← Type
Triggers on a UniPro Trigger Upper2 frame. This control frame is used for link startup
sequence.
Errors ← Type
Triggers on the specified M-PHY or UniPro error frame.
M-PHY and USB SSIC (option R&S RTP-K44 and K64)
To Next Page
Loading...
