Rohde & Schwarz RTP Series - Page 736

Protocol analysis
R&S
®
RTP
736User Manual 1337.9952.02 ─ 12
DL PDU EOF ← Type
Searches for a UniPro DL PDU End Of Frame (EOF) that matches the specified FSN
or CRC condition.
DL PDU NAC ← Type
Searches for a UniPro DL PDU Negative Acknowledgment Control (NAC) frame that
matches the specified RReq or CRC condition.
DL PDU AFC ← Type
Searches for a UniPro DL PDU Acknowledgement and L2 Flow Control (AFC) frame
that matches the specified TC, CReq, FSN, Credit or CRC condition.
PACP ← Type
Searches for a UniPro PHY Adapter Control Protocol (PACP) frame that matches the
specified PACP Begin, PACP Function ID, Data, Index or CRC condition.
This control frame is used mainly for power mode change and L1.5 link management.
It is also used in scrambling request.
Trigger Upper0 ← Type
Searches for a Trigger Upper0 frame. This control frame is used for link startup
sequence.
Trigger Upper1 ← Type
Searches for a Trigger Upper1 frame. This control frame is used for link startup
sequence.
Trigger Upper2 ← Type
Searches for a Trigger Upper2 frame. This control frame is used for link startup
sequence.
Errors ← Type
Searches for the specified error frame.
LCC Type
Selects the type of LCC command to be searched for.
"Any LCC Command"
All the available LCC commands
"HIBERN8-SLEEP"
Switches the power-saving state to ultra-low power without configura-
tion loss. This state saves up to 90% power and is used with PWM
burst.
"HIBERN8-STALL"
Switches the power-saving state to ultra-low power without configura-
tion loss. This state saves up to 75% power and is used with HS
burst.
"READ-CAPABILITY"
Recovers data about the Optical Media Converter (OMC) capabilities
M-PHY and USB SSIC (option R&S RTP-K44 and K64)