Protocol analysis
R&S
®
RTP
897User Manual 1337.9952.02 ─ 12
TLP (Transaction layer)
Specifies the search conditions for the transaction layer type search.
TLP ← TLP (Transaction layer)
Searches for a transaction type.
"Any type"
Searches for any transaction type.
"Mem"
Searches for memory transaction type used for data transfers to
memory-mapped locations.
"IO"
Searches for I/O transaction type used for data transfers to I/O-map-
ped locations.
"Cfg"
Searches for configuration transaction type used to setup the device
functions.
"Msg"
Searches for message transaction type used for transmitting diverse
messages.
"Cpl"
Searches for completion without data.
"FetchAdd"
Searches for fetch and add atomic op request.
"Swap"
Searches for unconditional swap atomic op request.
"CAS"
Searches for compare and swap atomic op request transaction type.
Remote command:
SEARch:TRIGger:PCIE:TLP:TYPE on page 2162
Sequence Number ← TLP (Transaction layer)
Searches for a sequence number, which indicates if any TLPs have been lost.
Remote command:
SEARch:TRIGger:PCIE:TLP:SNUM on page 2161
TC ← TLP (Transaction layer)
Searches for a traffic class which is mapped on a specific virtual channel. The TC label
is transmitted unmodified through the fabric.
Remote command:
SEARch:TRIGger:PCIE:TLP:TCHN on page 2161
Ordering ← TLP (Transaction layer)
Searches for an ordering. The ordering can be relaxed or strong.
PCIe (option R&S
RTP-K72/K73)
To Next Page
Loading...
