Rohde & Schwarz RTP Series - Page 898

Protocol analysis
R&S
®
RTP
898User Manual 1337.9952.02 ─ 12
Remote command:
SEARch:TRIGger:PCIE:TLP:ORDE on page 2160
Snoop ← TLP (Transaction layer)
Searches for a snoop state.
Remote command:
SEARch:TRIGger:PCIE:TLP:SNOO on page 2161
Requester ID ← TLP (Transaction layer)
Searches for a requester ID, consisting of the requester's bus number, device number,
and function number.
Remote command:
SEARch:TRIGger:PCIE:TLP:REID on page 2161
Device ID ← TLP (Transaction layer)
Searches for a device ID, a field that can be assigned a value by the vendor for classi-
fying root complex register blocks (RCRB). The Device ID is only valid for Configura-
tion transaction. It is composed of 8-bit Bus number, 5-bit Device number and a 3-bit
Function number.
Remote command:
SEARch:TRIGger:PCIE:TLP:DEID on page 2159
Read/Write ← TLP (Transaction layer)
Searches for a read and/ or write state.
Remote command:
SEARch:TRIGger:PCIE:TLP:MERW on page 2160
Address Type ← TLP (Transaction layer)
Searches for an address type. The address type can be 32 bit or 64 bit.
Remote command:
SEARch:TRIGger:PCIE:TLP:ADRT on page 2158
Type ← TLP (Transaction layer)
Searches for a configuration type.
Remote command:
SEARch:TRIGger:PCIE:TLP:CFGT on page 2159
Routing ← TLP (Transaction layer)
Searches for a selected message routing type.
Remote command:
SEARch:TRIGger:PCIE:TLP:MSGR on page 2160
Message Code ← TLP (Transaction layer)
Searches for a specific message code.
Remote command:
SEARch:TRIGger:PCIE:TLP:MSGC on page 2160
PCIe (option R&S
RTP-K72/K73)