Rohde & Schwarz RTP Series - Page 905

Protocol analysis
R&S
®
RTP
905User Manual 1337.9952.02 ─ 12
"CRC16 error"
Searches for 16-bit cyclic redundancy check (CRC) errors.
"LCRC error"
Searches for link cyclic redundancy check (LCRC) errors.
"ECRC error"
Searches for end-to-end cyclic redundancy checksum (ECRC) errors.
"Unknown
packet"
Searches for an unknown packet.
"Length error"
Searches for a length
"Malformed
error"
Searches for a malformed TLP: a TLP that violates specific TLP for-
mation rules that are defined in the specification.
"Value out of
range"
Triggers, if a value is out of range.
"Prefix order
error"
Searches for a wrong prefix order.
"Max end to
end prefix"
Searches for an end-end prefix error. The maximum number of per-
mitted end-end TLP prefixes is 4.
"Sync bit"
Searches for a sync bit.
Remote command:
SEARch:TRIGger:PCIE:ERRC:LENGth on page 2155
SEARch:TRIGger:PCIE:ERRC:MALFormed on page 2155
SEARch:TRIGger:PCIE:ERRC:MXPFix on page 2156
SEARch:TRIGger:PCIE:ERRC:PFORder on page 2156
SEARch:TRIGger:PCIE:ERRC:SYCBit on page 2156
SEARch:TRIGger:PCIE:ERRC:UKNP on page 2156
SEARch:TRIGger:PCIE:ERRC:VOORange on page 2156
13.22.6.2 PCIe Gen 1/2 search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
PCIe (option R&S
RTP-K72/K73)