Protocol analysis
R&S
®
RTP
906User Manual 1337.9952.02 ─ 12
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
The results of the search are the same as for decoding, see Chapter 13.23.3, "DDR
decode results", on page 914.
Remote Commands:
●
SEARch:RESult:PCIE:PCOunt? on page 2168
●
SEARch:RESult:PCIE:PACKet<m>:ADDR? on page 2163
●
SEARch:RESult:PCIE:PACKet<m>:CPID? on page 2163
●
SEARch:RESult:PCIE:PACKet<m>:CPS? on page 2163
●
SEARch:RESult:PCIE:PACKet<m>:DATA? on page 2163
●
SEARch:RESult:PCIE:PACKet<m>:DFC? on page 2164
●
SEARch:RESult:PCIE:PACKet<m>:FCOunt? on page 2164
●
SEARch:RESult:PCIE:PACKet<m>:HFC? on page 2165
●
SEARch:RESult:PCIE:PACKet<m>:LEN? on page 2166
●
SEARch:RESult:PCIE:PACKet<m>:RQID? on page 2166
●
SEARch:RESult:PCIE:PACKet<m>:SEQN? on page 2166
●
SEARch:RESult:PCIE:PACKet<m>:STARt? on page 2167
●
SEARch:RESult:PCIE:PACKet<m>:STATe? on page 2167
●
SEARch:RESult:PCIE:PACKet<m>:STOP? on page 2167
●
SEARch:RESult:PCIE:PACKet<m>:TAG? on page 2167
●
SEARch:RESult:PCIE:PACKet<m>:TYPE? on page 2168
●
SEARch:RESult:PCIE:PACKet<m>:FCOunt? on page 2164
●
SEARch:RESult:PCIE:PACKet<m>:FLD<n>:FVAL? on page 2164
●
SEARch:RESult:PCIE:PACKet<m>:FLD<n>:STATus? on page 2165
●
SEARch:RESult:PCIE:PACKet<m>:FLD<n>:TYPE? on page 2165
●
SEARch:RESult:PCIE:PACKet<m>:FLD<n>:VAL? on page 2165
13.22.6.3 Searching for PCIe Gen 1/2
Prerequisite: A serial bus is configured for the PCIe signal to be decoded and ana-
lyzed.
The search for events is set up in the following way:
1. Press [Search] or tap "Search" > "Setup" in the menu bar.
2. If the dialog box does not contain a search entry, tap the "Add" icon to create one,
as described in "To create a user-defined search" on page 463.
PCIe (option R&S
RTP-K72/K73)
To Next Page
Loading...
Need help?
General
