Rohde & Schwarz RTP Series - Page 917

Protocol analysis
R&S
®
RTP
917User Manual 1337.9952.02 ─ 12
You can configure and analyze up to four independent eye diagrams in parallel (vertical
subtabs E1 to E4). Make sure to select the correct eye diagram subtab on the left
before you adjust the settings.
State............................................................................................................................917
Main source.................................................................................................................917
Timing reference......................................................................................................... 918
└ Source...........................................................................................................918
└ Slope / Vertical ref. level............................................................................... 918
Horizontal settings.......................................................................................................918
└ Time units......................................................................................................918
└ Range, Position.............................................................................................918
└ Bit rate, Range UI, Position UI......................................................................918
State
Activates or deactivates the eye diagram.
Remote command:
EYE<m>[:STATe] on page 2185
Main source
Selects the waveform from which the eye diagram is generated (data source).
Select the same channel for the DDR serial bus protocol configuration "DQ" data line
and the input for the eye diagram.
Remote command:
EYE<m>:SOURce on page 2185
DDR (option R&S
RTP-K91/K93 )