Scanlab RTC6 PCIe Board - Page 309

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
309
innovators for industry
Control Commands for RTC6 Ethernet
Boards
eth_assign_card ...................................... 353
eth_assign_card_ip ................................. 354
(n_) eth_check_connection ........................... 356
(n_) eth_configure_link_loss ......................... 357
eth_convert_ip_to_string ....................... 358
eth_convert_string_to_ip ....................... 359
eth_count_cards ..................................... 360
eth_found_cards .................................... 361
eth_get_card_info .................................. 362
eth_get_card_info_search ...................... 363
(n_) eth_get_com_timeouts .......................... 364
(n_) eth_get_com_timeouts_auto ................. 365
(n_) eth_get_error .......................................... 366
eth_get_ip ............................................... 367
eth_get_ip_search .................................. 367
(n_) eth_get_last_error ...
............................... 368
(n_) eth_get_port_numbers .......................... 370
eth_get_serial_search ............................. 370
(n_) eth_get_standalone_status ................... 371
(n_) eth_get_static_ip .................................... 372
eth_max_card ......................................... 373
eth_remove_card .................................... 374
eth_search_cards .................................... 375
eth_search_cards_range ........................ 376
(n_) eth_set_com_timeouts ........................... 377
(n_) eth_set_com_timeouts_auto ................. 378
(n_) eth_set_high_performance_mode ........ 379
(n_) eth_set_port_numbers ........................... 380
(n_) eth_set_remote_tgm_format ................ 381
eth_set_search_cards_time
out .............. 382
(n
_) eth_set_static_ip .................................... 383
(n_) time_control_eth .................................... 809
Standalone Functionality for RTC6 Ethernet
Boards
(n_) eth_boot_dcmd ...................................... 355
(n_) eth_boot_timeout .................................. 355
(n_) set_eth_boot_control ............................. 636
(n_) read_image_eth ...................................... 581
(n_) store_program ........................................ 800
(n_) write_image_eth .................................... 859
Other Control Commands
(n_) auto_cal .................................................. 332
(n_) bounce_supp .......................................... 337
(n_) create_dat_file ........................................ 349
(n_) get_auto_cal ........................................... 393
(n_) get_card_type ......................................... 394
(n_) get_galvo_controls ................................. 403
(n_) get_hi_data ............................................. 408
(n_) get_hi_pos ...
........................................... 409
(n_) get_temperature .................................... 434
(n_) get_time .................................................. 435
(n_) get_timestamp_long .............................. 436
(n_) home_position ....................................... 452
(n_) home_position_xyz
(1)
............................ 453
(n_) load_zoom_correction_file .................... 522
(n_) move_to .................................................. 550
(n_) set_hi ....................................................... 659
(n_) set_mcbsp_out_oie_ctrl ......................... 696
(n_) set_pause_list_cond ............................... 709
(n_) set_timelag_compensation .................... 750
(n_) set_zoom ................................................ 780
(n_) store_timestamp_counter ..................... 801
(n_) write_hi_pos ........................................... 858
(1) Limited functionality if no Option “3D”.