Scanlab RTC6 PCIe Board - Page 755

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
755
innovators for industry
Parameters
(cont’d)
Signal1
(cont’d)
43 Counter value of encoder counter “Encoder0”
44 Counter value of encoder counter “Encoder1”
45 Marking speed
From set_mark_speed, set_mark_speed_ctrl.
46 16-bit digital input port (EXTENSION 1)
47 Only for intelliWELD II: Zoom value
48 FreeVariable4
49 FreeVariable5
50 FreeVariable6
51 FreeVariable7
52 32-bit “Timestamp Counter”
See Chapter 8.12 ”Time Measurements”, page 281.
Delayed Short
List Command
set_trigger