Scanlab RTC6 PCIe Board - Page 874

RTC6 boards
Doc. Rev. 1.0.21 en-US
15 Technical Specifications – RTC6 PCIe Board
874
innovators for industry
EXTENSION 1 Socket Connector
Connector 40-pin socket connector,
output signal level
configurable by jumper
Digital output 16 bits, buffered
• LOW level < 0.4 V
• HIGH level > 2.0 V (3.3 V or 5 V)
• Max. current load ±8 mA
• Reference GND
(a)
• LATCH signal 3.3 V or 5 V,
TTL active-HIGH,
5 µs pulse, max. 10 mA
Digital input port 16 bits
• LOW level < 0.5 V
• HIGH level > 2.6 V…24 V
• Max. input voltage
range
–0.5 V…+26 V
• Input resistance > 10 k
• Reference GND
(a)
• SYNC signal 3.3 V or 5 V, TTL
active-HIGH, square wave
signal (5 µs pulse, 10 µs
period)
max. 10 mA
Other signals
• BUSY OUT 3.3 V or 5 V,
TTL active-HIGH,
max. 10 mA
• VCC 3.3 V or 5 V,
max. 100 mA
• +5 V max. 100 mA
• Reference GND
(a)
EXTENSION 2 Socket Connector
Connector 26-pin socket connector,
configurable by jumper
Digital output 8 bits, buffered
• LOW level < 0.4 V
• HIGH level > 2.0 V
• Max. current load ±8 mA
• Reference GND
(a)
• LATCH signal 5 V, TTL active-HIGH,
5 µs pulse, max. 10 mA
Laser Control Signals LASERON, LASER1, LASER2
(see LASER Connector,
page 873)
Other signals
• +5 V max. 100 mA
• Reference GND
(a)
MARKING ON THE FLY Socket Connector
Connector 16-pin socket connector
2 encoder input ports
for incremental
encoders
ENCODER X(1±,2±) and
ENCODER Y(1±,2±),
designed for a pair of
standardized differential
input signals (RS-422)
each.
HIGH level  2.0 V
LOW level  0.8 V)
f  4 MHz
Analog outputs ANALOG OUT2
(see LASER Connector)
Input ports for external
start and stop signals
/START2, /STOP2
(see /START, /STOP of the
LASER Connector)
Other signals
• BUSY OUT 5 V, TTL active-HIGH,
max. 10 mA
• +5 V max. 100 mA
• Reference GND
(a)