Scanlab RTC6 PCIe Board - Page 873

RTC6 boards
Doc. Rev. 1.0.21 en-US
15 Technical Specifications – RTC6 PCIe Board
873
innovators for industry
LASER Connector
Connector 15-pin D-SUB connector
(female)
Laser Control Signals LASER1, LASER2, LASERON
• TTL level 5 V, active-HIGH or
active-LOW
(programmable)
• Max. current load 20 mA
• Reference GND
(a)
(GND2 with Option
“DC/DC Converter”)
(a) See footnote on page 73.
Analog outputs ANALOG OUT1,
ANALOG OUT2
• Output voltage
range
0 V…10 V
• Resolution 12 Bit
• Max. current load 5 mA
• Reference GND
(a)
Digital input port 2 Bits
• LOW level < 0.6 V
• HIGH level > 2.3 V
• Max. input voltage
range
–0.5 V…+5.5 V
• Input resistance
(pull-up)
> 4.7 k
• Reference GND
(a)
Digital output 2 bits, buffered
• LOW level < 0.55 V
• HIGH level > 3.8 V
• Max. current load 20 mA
• Reference GND
(a)
Input ports for external
start and stop signals
TTL active-LOW, internally
connected to +3.3 V by
pull-up resistors (4.7 k)
• /START edge sensitive
HIGH level > 2.3 V
LOW level < 0.6 V
• /STOP level sensitive
HIGH level > 2.3 V
LOW level < 0.6 V
• Reference GND
(a)
Other signals
• BUSY OUT 5 V, TTL active-HIGH,
max. 10 mA
• +5 V max. 100 mA
• Reference GND
(a)