Scanlab RTC6 PCIe Board - Page 915

RTC6 boards
Doc. Rev. 1.0.21 en-US
16 Appendix A: The RTC6 Ethernet Board
915
innovators for industry
(5) In Boot Phase 2:
(1)
– The BUSY Pin is switched on
– The RTC6 List Memory is read out
(duration: approx. 1 minute)
– Boot Phase 2-control commands are executed.
– Initialization ceases
– The BUSY Pin is switched off
(6) After Boot Phase 2:
– If an error has occurred
(2)
(further operation of
the board may not be possible), the LED
continues to flash at about 4 Hz
– When the initialization is successfully
completed
(3)
, the dimmed LED flashing stops.
The LED returns to its normal state, see
Chapter 16.2.7 ”ETH Connector”, page 887
– The target state of the RTC6 Ethernet Board
indicates
eth_get_standalone_status( & Mode =1…2 ).
– At this point, it would be a suitable
point in time to also switch on the laser
(observe the notices on laser safety in
Chapter 3.2 ”Laser Safety”, page 63) as well as
other peripherals.
– The RTC6 Ethernet Board waits endlessly for an
/START, which starts the processing of the list
– The RTC6 Ethernet Board is ready for
PC operation as well
(1) eth_get_standalone_status( & Status == 1 )
(2) eth_get_standalone_status( & Error = 1 )
(3) eth_get_standalone_status( & Status =0 )