6.4.1 Preliminary steps
Ê "Locating the defective server" on page 57
Ê Remove the AC power cord from its cable bracket and disconnect it from the
PSU module to be replaced as described in section "Disconnecting the
server from the mains" on page 63.
6.4.2 Removing the defective PSU module
Ê Identify the defective PSU module using the server management software.
Ê Remove the defective PSU module as described in section "Removing a
PSU module" on page 171.
6.4.3 Installing the new PSU module
Ê Replace the defective PSU module as described in section "Installing a PSU
module" on page 168.
6.4.4 Concluding steps
Ê "Connecting the server to the mains" on page 118
Ê If applicable, switch on the server.
Ê "Performing a fan test after replacing a defective fan" on page 145
To Next Page
Loading...
Need help?
General