Ê "Locating the defective server" on page 57
Ê "Shutting down the server" on page 62
Ê "Disconnecting the server from the mains" on page 63
Ê Remove all external cables from the expansion card to be replaced.
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section "Opening the server" on
page 68.
Ê "Removing the system air duct" on page 81
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs as described in section "Onboard indicators and controls" on
page 779.
9.3.3.2 Removing the Modular LAN controller
Ê If applicable, remove SFP+ transceiver modules from the Modular LAN
controller to be removed.
Ê Remove the defective Modular LAN controller as described in section
"Removing the Modular LAN controller" on page 373.
Ê If the slot bracket on the defective Modular LAN controller is to be reused,
remove it from the board as described in section "Preparing the Modular
LAN controller" on page 365.
9.3.3.3 Installing the Modular LAN controller
Ê If applicable, install a slot bracket on the new Modular LAN controller as
described in section "Preparing the Modular LAN controller" on page 365.
Ê Install the new Modular LAN controller as described in section "Installing the
Modular LAN controller" on page 364.
Ê If applicable, reinstall SFP+ transceiver modules on the new Modular LAN
controller.
To Next Page
Loading...
