Ê Pull the LSD module out of the 3.5-inch installation frame (2).
Ê If the removed LSD module is not to be replaced by a new module, reinstall
the LSD dummy cover.
12.5.2.5 Installing accessible drive dummy covers
I if the 4x 3.5-inch HDD extension box is to be reinstalled in the system,
the following description does not apply. Please proceed as described in
section "Installing the 4x 3.5-inch HDD extension box" on page 296.
Installing accessible drive filler covers
Ê Install an accessible drive filler cover (C26361-K644-C933) into the empty
installation bay 1 as described in section "Accessible drive filler covers" on
page 94.
V CAUTION!
Always replace filler covers into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
Installing accessible drive covers
Ê Install an accessible drive cover (C26361-K644-C60) into installation bay 1
of the front cover as described in section "Accessible drive covers" on
page 96.
12.5.2.6 Concluding steps
Ê "Installing the system fan holder" on page 331
Ê "Installing the system air duct" on page 83
Ê "Closing the server" on page 98
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê "Connecting the server to the mains" on page 118
To Next Page
Loading...
