Ê Fit the slimline ODD dummy insert into the slimline ODD installation frame.
Ê Ensure that the four pins on the frame (see arrows) engage with the side
holes on the dummy insert.
Ê Insert the slimline ODD dummy module into the Multibay box and push back
until the locking tab engages as shown in figure 422 on page 553.
12.5.2.4 Removing the LSD module from the Multibay box
Figure 434: Removing the 3.5-inch installation frame from the Multibay box (A)
Ê Remove two screws on either side of the Multibay box to disengage the 3.5-
inch installation bay.
To Next Page
Loading...
Need help?
General