14.6.4 Concluding steps
Ê Reconnect all remaining cables to the system board. For a complete cabling
overview, please refer to section "Cabling overviews" on page 738.
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: refer to section "Installing processor heat sinks" on page 519
– Memory modules: refer to section "Installing a memory module" on
page 477
I Install all memory modules into their original slots.
– Expansion cards: refer to section "Installing a memory module" on
page 477
I Install all expansion cards into their original slots.
– UFM board (if applicable): refer to section "Installing the UFM board" on
page 649
– TPM board (if applicable): refer to section "Installing the TPM board" on
page 661
– iRMC microSD card (if applicable): refer to section "Installing the iRMC
microSD card" on page 679
Ê Reinstall all fan modules and fan holders as described in the related
sections:
– "Installing the system fan holder" on page 331
– "Installing system fan modules" on page 327
– "Installing the rear fan holder" on page 342
– "Installing rear fan modules" on page 332
Ê "Installing the system air duct" on page 83
Ê "Closing the server" on page 98
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
"D2949 BIOS Setup Utility for PRIMERGY TX300 S8 / RX350 S8
Reference Manual".
To Next Page
Loading...
