Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê Reconnect all external cables.
Ê "Connecting the server to the mains" on page 118
Ê Update the system board BIOS and iRMC to the latest version as described
in section "Updating or recovering the system board BIOS and iRMC" on
page 134.
Ê Verify whether the backup data on the Chassis ID EPROM has been
restored to the system board as described in section "Verifying system
information backup / restore" on page 136.
Ê "Verifying the system time settings" on page 148
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section "Looking up changed MAC / WWN addresses"
on page 153.
Ê After replacing the system board in a server running Linux OS, update the
MAC address of the onboard network controller in the related NIC definition
file as described in section "Updating the NIC configuration file in a Linux
environment" on page 150.
Ê "Enabling SVOM boot watchdog functionality" on page 146
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task: "Resuming BitLocker functionality" on page 152
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I Configuration of network settings should be performed by the
customer.
For further information, please refer to section "Note on network
settings recovery" on page 685.
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing the system board" on page 157.
To Next Page
Loading...
