Ê Align the notch on the bottom of the module with the crossbar in the
connector (see close-up).
Figure 362: Installing memory modules (C)
Ê Press down on the memory module until the securing clips snap into the
cutouts at each end of the module.
10.2.3 Concluding steps
Ê "Installing the system air duct" on page 83
Ê "Closing the server" on page 98
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê "Connecting the server to the mains" on page 118
Ê If available, update the system board BIOS to the latest version as described
in section "Updating or recovering the system board BIOS and iRMC" on
page 134.
Ê "Enabling SVOM boot watchdog functionality" on page 146
Ê If applicable, configure the memory mode as described in section "Verifying
the memory mode" on page 147.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task: "Resuming BitLocker functionality" on page 152
To Next Page
Loading...
