10.4.2 Removing the defective memory module
Ê "Removing memory modules" on page 479
10.4.3 Installing a new memory module
Ê "Installing memory modules" on page 476
10.4.4 Concluding steps
Ê "Installing the system air duct" on page 83
Ê "Closing the server" on page 98
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê "Connecting the server to the mains" on page 118
Ê If available, update the system board BIOS to the latest version as described
in section "Updating or recovering the system board BIOS and iRMC" on
page 134.
Ê "Resetting the error status after replacing memory modules or processors"
on page 142
Ê "Enabling SVOM boot watchdog functionality" on page 146
Ê "Enabling replaced components in the system BIOS" on page 147
Ê Verify if the memory mode has been restored to its original state as
described in section "Verifying the memory mode" on page 147.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task: "Resuming BitLocker functionality" on page 152
To Next Page
Loading...
Need help?
General