7.2.7.3 Installing a 2.5-inch HDD / SSD dummy module
V CAUTION!
If the removed HDD / SSD module is not replaced immediately, always
replace a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 114: Installing a 2.5-inch HDD / SSD dummy module
Ê Slide the HDD dummy module into the drive bay until it locks in place.
7.2.7.4 Concluding steps
Ê When working on a tower server, close the HDD bay cover as described in
section "Installing accessible drive and HDD bay covers" on page 105.
To Next Page
Loading...
