● Never attempt to disassemble a hard disk or solid state drive.
● For further safety information, please refer to chapter "Important
information" on page 45.
7.1 Basic information
For best performance, the following mounting sequence is recommended:
– Solid state drives (SSDs) are always equipped before installing hard disk
drives.
– Hard disk drives / solid state drives with different capacities are installed
from highest to lowest capacity.
– Hard disk drives with different rotation speeds are installed from highest to
lowest speed.
– When installing hard disk drives with different bus technologies (SAS or
SATA), first install SAS drives and then SATA drives.
– Please refer to section "2.5-inch HDD / SSD configurations" on page 185 for
a complete overview of the mounting sequence.
– Install dummy modules into unused HDD / SSD bays.
To Next Page
Loading...
