Ê "Connecting the server to the mains" on page 118
Ê In order to configure an expansion card that has been installed or replaced,
the card’s Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section "Enabling Option ROM scan" on
page 138.
Ê "Enabling SVOM boot watchdog functionality" on page 146
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task: "Resuming BitLocker functionality" on page 152
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page 157
9.3.1.6 Concluding software tasks
If the Modular LAN controller is to be used as a shared LAN interface, please
proceed as follows:
Ê Ensure that the NCSI cable has been connected to the Modular LAN
controller and the system board as described in sections "Connecting the
NCSI sideband cable to the Modular LAN controller" on page 366 and
"Connecting the NCSI sideband cable to the system board" on page 370.
Ê Enter the BIOS.
Ê Select the Server Mgmt menu.
Ê Under iRMC LAN Parameters Configuration set the Management LAN Port
setting to Shared 2.
Ê Save your changes and exit the BIOS.
I For detailed information on how to access the BIOS and modify settings,
refer to the "System Board D2949 BIOS Setup Utility" reference manual.
To Next Page
Loading...
Need help?
General