12.2.5 Concluding steps
Ê "Installing the system fan holder" on page 331
Ê "Installing the system air duct" on page 83
Ê "Closing the server" on page 98
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê "Connecting the server to the mains" on page 118
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page 139.
12.3 Removing accessible drives
12.3.1 Preliminary steps
Ê "Locating the defective server" on page 57
Ê "Removing backup and optical disk media" on page 129
Ê "Verifying and configuring the backup software solution" on page 129
Ê "Shutting down the server" on page 62
Ê "Disconnecting the server from the mains" on page 63
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
Upgrade and Repair Unit
(URU)
Average task duration:
10 minutes
Tools: tool-less
To Next Page
Loading...
Need help?
General