Ê Carefully pull the accessible drive out of its installation bay.
Ê Engage the locking bar as described in section "Closing the accessible drive
locking bar" on page 93.
12.3.3 Installing accessible drive dummy covers
Ê Install accessible drive filler covers as described in section "Accessible drive
filler covers" on page 94.
Ê Install accessible drive covers as described in section "Accessible drive
covers" on page 96.
12.3.4 Concluding steps
Ê "Installing the system fan holder" on page 331
Ê "Installing the system air duct" on page 83
Ê "Closing the server" on page 98
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê "Connecting the server to the mains" on page 118
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page 139.