HP DesignJet T730

●
All applications, including virus protection programs, spyware protection programs, and rewalls,
are closed or disabled for computers running Windows.
●
The printer is installed on the same subnet as the computers that use the printer.
If the installation program cannot discover the printer, print the Network Conguration Page, and enter
the IP address manually in the installation program.
Although assigning a static address to the printer is not recommended, some installation problems
(such as a conict with a personal rewall) may be resolved by doing so.
Network port created does not match printer IP address (Windows)
If the computer is running Windows, make sure that the network ports created in the printer driver match the
printer's IP address.
1. Print the printer’s Network Conguration Page.
2. From Start > Set up, and then click Printers or Printers and Faxes. - or - From Start > Front Panel, and
then double-click Printers.
3. Right-click the printer icon, click Properties, and then click the Ports tab.
4. Select the TCP/IP port for the printer, and then click Congure Port.
5. Compare the IP address listed in the dialog box and make sure it matches the IP address listed on the
Network Conguration Page. If the IP addresses are dierent, change the IP address in the dialog box to
match the address on the Network Conguration Page..
6. Click OK twice to save the settings and close the dialog boxes.
Wireless network issues
1. Make sure the wireless (802.11) light at the top left of the front panel is turned on .
If the blue light is not lit, the wireless capabilities may not have been turned on. Swipe down the
dashboard and press , then scroll down the menu and press Network Set Up > Wireless Settings >.On.
2. Make sure that an Ethernet cable has not been connected to the printer. Connecting an Ethernet cable
turns o the printer's wireless capabilities.
3. Restart components of the wireless network.
Turn o the router and the printer, and then turn them back on in this order: the router rst, and then
the printer. Then run the Wireless Setup wizard in the front panel and select your network. If you still are
unable to connect, turn o the router, printer, and computer. Sometimes, turning o the power and then
turning it back on recovers a network communication issue.
4. Run the Wireless Network Test.
For wireless networking issues, run the Wireless Network Test. To print a Wireless Network Test page,
scroll down the dashboard and press , then scroll down the menu and press Network Set Up > Print
Reports >.Wireless Test Report. If a problem is detected, the printed test report includes
recommendations that could help to solve the problem.
5. If required, print the Network Conguration Page to check deep network status information.
NOTE: The wireless connection can be aected by the location of the network router and the device. In order
to improve your wireless connection:
112 Chapter 2 Troubleshooting ENWW