HP DesignJet T730

W/F # Description Internal details Troubleshooting
F 604 Non-default WEP
Authentication
The printer is congured to connect to a WEP wireless
network (%s), and the printer’s congured
authentication method (\"%s\") has been changed
from its default setting (\"Automatic (Open then
Shared)\").
This could potentially cause the printer to be unable
to connect to the wireless network. The printer’s
default setting should always work and avoids any
potential future problems. Unless you know that the
printer’s current setting is correct for your wireless
network, it is recommended that this setting be
changed back to the default. Refer to the
documentation that came with the printer for
information on how to congure the WEP
authentication method.
The rst %s parameter will be the SSID name found in
the network scan , the second %s parameter will be
the actual value of the setting.
ATTENTION: The WEP key
authentication setting on your printer
has been congured to a non-default
setting. This may cause problems
when connecting to your wireless
network if your wireless router is not
using the same WEP authentication
method.
SOLUTION 1: Refer to your printer
documentation for information on
conguring WEP.
F 605 Non-default WPA
Encryption
The printer is congured to connect to a WPA-PSK
wireless network, (%s) and the printer’s congured
encryption method (\"%s\") has been changed from
its default setting (\"Automatic (AES or TKIP)\").
This could potentially cause the printer to be unable
to connect to the wireless network. The printer’s
default setting should always work and avoids any
potential future problems. Unless you know that the
printer’s current setting is correct for your wireless
network, it is recommended that this setting be
changed back to the default. Refer to the
documentation that came with the printer for
information on how to congure the WPA-PSK
encryption method.
The rst %s parameter will be the SSID name found in
the network scan , the second %s parameter will be
the actual value of the setting.
ATTENTION: The WPA encryption
method on your printer has been
congured to a non-default setting.
This may cause problems when
connecting to your wireless network
if your wireless router is not using the
same WPA encryption method.
SOLUTION 1: Refer to your printer
documentation for information on
conguring WPA.
ENWW Wireless troubleshooting report error cases 555