Keysight Technologies P Series - Page 175

MEASurement Commands 2
Keysight N8262A Programming Guide 175
Example
resolution A numeric value for the resolution. If unspecified the current
resolution setting is used.
1 to 4
[b]
1.0, 0.1, 0.01, 0.001
DEF
[a]
source list The channel which the command is implemented on.
If unspecified the current window setup is used. However, if the
window shows a ratio or difference measurement, the upper
window defaults to Channel A and the lower window to Channel B.
(@1)
(@2)
[a] The mnemonic DEF means DEFault. This is not equivalent to the DEFault parameter used in the command sub-systems. The parameters must
be entered in the specified order. If parameters are omitted, they default from the right. The parameter DEFault is used as a place holder.
Specifying DEF leaves the parameter value unchanged.
[b] When the measurement result is linear this parameter represents the number of significant digits. When the measurement result is
logarithmic 1 to 4 represents of 1, 0.1, 0.01 and 0.001 respectively.
MEAS1:REL? -50DBM,2,(@2) This command queries the upper window/
upper measurement relative measurement of
Channel B, using an expected power level of
–50 dBm and a resolution setting of 2.
Item Description/Default Range of Values