Keysight Technologies P Series

10 SENSe Subsystem
368 Keysight N8262A Programming Guide
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2 Commands
These commands are used to select the active sensor calibration table (using
CSET1) and the active frequency dependent offset table (using CSET2).
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2[:SELect] <string>
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:STATe <boolean>
NOTE
If any of the CSET1 commands are used when a P-Series or E-Series power
sensor is connected, the error –241, “Hardware missing” occurs.