Keysight Technologies P Series

10 SENSe Subsystem
388 Keysight N8262A Programming Guide
[SENSe[1]]|SENSe2:MRATe <character_data>
This command sets the measurement speed on the selected channel.
When a channel is set to FAST, the following couplings occur:
Command Status
[SENSe[1]]|SENSe2:AVERage:STATe
OFF
[a]
[SENSe[1]]|SENSe2:CORRection:DCYCle:STATe
OFF
[a]
[SENSe[1]]|SENSe2:CORRection:GAIN2:STATe
OFF
[a]
CALCulate[1|2|3|4]:GAIN:STATe
OFF
[b]
CALCulate[1|2|3|4]:RELative:STATe
OFF
[b]
CALCulate1|3:MATH:EXPRession
“(SENSe1)”
CALCulate2|4:MATH:EXPRession
“(SENSe2)”
[a] This change only occurs on the channel specified in the SENSe:MRATe command. When the specified channel is changed from FAST to
NORMal or DOUBle, the settings that were in place when FAST was entered are restored.
[b] This change occurs when either channel is set to FAST. When both channels are changed from FAST to NORMal or DOUBle, the settings
that were in place when FAST was entered are restored.