Keysight Technologies P Series

12 SYSTem Subsystem
478 Keysight N8262A Programming Guide
[SENS[1]]|SENS2:CORR:CSET[1]|CSET2:STAT not affected Sensor calibration table disabled
[SENS[1]]|SENS2:CORR:DCYC|GAIN3
[:INP][:MAGN]
1.000 % Duty cycle factor
[SENS[1]]|SENS2:CORR:DCYC|GAIN3:STAT OFF Duty cycle correction disabled
[SENS[1]]|SENS2:CORR:FDOF|GAIN4
[:INP][:MAGN]
not affected Return frequency dependent offset
[SENS[1]]|SENS2:CORR:GAIN2:STAT OFF Channel offset disabled
[SENS[1]]|SENS2:CORR:GAIN2:STAT
[:INPut][:MAGNitude]
0.0 dB Enter channel offset value
[SENS[1]]|SENS2:DET:FUNC NORM Measurement mode
[SENS[1]]|SENS2:FREQ[:CW|:FIX] +50.000 MHz Frequency setting
[SENSe[1]]|SENS2:MRAT NORM Measurement speed
[SENS[1]]|SENS2:POW:AC:RANG upper Upper range selected
[SENS[1]]|SENS2:POW:AC:RANG:AUTO ON Auto-ranging selected
[SENS[1]]|SENS2:SPE 20 readings/second Speed
[SENS[1]]|SENS2:SWE[1]|2|3|4:OFFS:TIME 0 Set delay
[SENS[1]]|SENS2:SWE[1]|2|3|4:TIME Gate 1: 100 µs Other
gates: 0 sec
Set time gated period
[SENS[1]]|SENS2:TRACe:OFFSet:TIME 0 Delay
[SENS[1]]|SENS2:TRACe:TIME 100 µs Duration of trace
[SENS[1]]|SENS2:V2P ATYP Select linearity correction
TRAC[1]|2:STAT OFF Disable trace capture
TRAC[1]|2:UNIT dBm Trace units
TRIG[1]|2:DEL:AUTO ON Insert settling time delay
TRIG[:SEQ]:DEL 0 Delay between recognition of trigger
event and start of a measurement
TRIG[:SEQ]:HOLD 1 µs Trigger holdoff
TRIG[:SEQ]:HYST 0 dB Fall/rise below/above TRIG:LEV
Table 12-1 DEFault: Power meter presets (continued)
Command Setting Comments