Leibinger JET2neo - Page 84

Page 82 Data entry/Programming Group 7
Release R1.12 en JET2 neo
Basic rules for the job list type <Extern job selection>:
 Each print job is managed separately.
 Each print job needs a <PrintGo> signal to be printed.
 If a single print job of the <External Job> job list has to be edited, this has to be carried
out with the job editor. The print job on the list has then to be exchanged against the
revised print job. It is not possible to edit a job on the job list directly.
 <PrintGo distance>, <PrintGo repetition> and the option for <endless> printing
have to be set within the single print jobs.
 An empty address will be ignored. The last addressed print job will remain in the print
storage.
 The WYSIWYG preview of the main window always shows the print job that will be
printed with the next <PrintGo> signal (14).
Example for external job selection
The following print jobs shall be printed in a defined order:
Order
Print job
1.
Joblist-Job-1
2.
Joblist-Job-7
3.
Joblist-Job-5
4.
Joblist-Job-3
5.
Joblist-Job-9
The print jobs are selected by binary addressing them at interface X4. With each PrintGo
signal the currently selected print job will be printed.