4. MEASUREMENT FLOW
Condition settings Default value Remark Related section
Overrange ESC Select one from ESC, ESC+, ESC-, and GO. 7.5.4 (page 7-52)
Arm correction OFF Set the arm correction to ON or OFF. 7.5.5 (page 7-53)
Auto-start OFF Set the auto-start function to ON or OFF. 7.5.6 (page 7-54)
Auto-return ON Sets the function that returns to measurement starting
position to ON/OFF.
7.5.7 (page 7-55)
Retraction OFF Sets the function that returns the detector to escape position
to ON/OFF.
7.5.8 (page 7-56)
X-axis operation ON Set the X-axis operation to ON or OFF. 7.5.9 (page 7-57)
Resume calculation OFF Set the function for resuming measurement after the process
is aborted to ON/OFF.
7.5.10 (page 7-57)
Application of GO/NG
judgment and the
range
None Set the upper or lower roughness limit to discriminate
between measured workpieces to be accepted or rejected.
8.3.7 (page 8-20)
No. 99MBB765A
4-11
To Next Page
Loading...
