3.3.3 Checking the zero point: for skid-attached measurement setup.................................... 3-13
3.3.4 Adjusting the nosepiece height: for skid-attached measurement setup ....................... 3-15
3.4 Mounting and Dismounting the Height/Tilt Adjustment Unit .................................................. 3-16
3.5 Attaching the Touch Panel Protection Sheet ............................................................................ 3-17
3.6 Attaching the Touch Pen Strap .................................................................................................. 3-18
3.7 Setting the Printer Paper ............................................................................................................ 3-19
3.8 Using the SD Card ....................................................................................................................... 3-21
3.8.1 Setting the SD card .............................................................................................................. 3-22
3.8.2 Removing the SD card ......................................................................................................... 3-23
3.9 Power Supply ............................................................................................................................... 3-24
3.9.1 Recharging the built-in battery ........................................................................................... 3-25
3.9.2 Turning on the power supply .............................................................................................. 3-27
3.9.3 Turning the power off .......................................................................................................... 3-30
3.10 Initial Settings .............................................................................................................................. 3-31
3.11 Attache Case ................................................................................................................................ 3-32
4 MEASUREMENT FLOW ........................................................................................................................ 4-1
4.1 Perform Measurement according to Overall Measurement Flow ............................................. 4-1
4.2 Perform Adjustment for Calibration and Measurement ............................................................. 4-2
4.2.1 Perform the vertical positioning ........................................................................................... 4-2
4.2.2 Perform the horizontal positioning ...................................................................................... 4-3
4.2.3 Perform zero adjustment ....................................................................................................... 4-3
4.2.4 Perform leveling ..................................................................................................................... 4-4
4.3 Perform Calibration ....................................................................................................................... 4-9
4.4 Modify the Condition Settings .................................................................................................... 4-10
4.5 Perform Measurement ................................................................................................................. 4-12
4.5.1 Set the workpiece and drive/detector unit. ....................................................................... 4-12
4.5.2 Start measurement .............................................................................................................. 4-14
4.5.3 To start measurement from an arbitrary position ............................................................. 4-15
4.6 Switch the Display of Measurement Results ............................................................................ 4-17
4.6.1 Switch the parameter to be displayed ............................................................................... 4-18
4.6.2 Display the evaluation profiles ........................................................................................... 4-18
4.6.3 Display the graph ................................................................................................................. 4-19
4.6.4 Display the GO/NG judgment result ................................................................................... 4-19
4.6.5 Display the results at each sampling length ..................................................................... 4-20
4.7 Print the Measurement Results .................................................................................................. 4-21
4.8 To Use Various Optional Accessories ....................................................................................... 4-23
5 OPERATION METHOD FOR THE DRIVE UNIT/DETECTOR /AUTOMATIC POSITIONING UNIT
(OPTIONAL ACCESSORIES) ............................................................................................................. 5-1
5.1 Operation Method of the Drive Unit Screens Guide................................................................... 5-1
5.2 Operation Method for the Drive Unit ........................................................................................... 5-3
5.2.1 Repositioning the drive unit manually ................................................................................. 5-3
5.2.2 Repositioning the drive unit for narrow-area measurement ............................................. 5-3
To Next Page
Loading...
