Home screen
4 Press .
Measurement Waveform Display screen
¾ The detector starts traversing to perform measurement.
While measurement is being performed (detector is
traversing), the measurement waveform display screen is
displayed.
NOTE
• Press during measurement to stop for
unavoidable reasons.
Home screen
¾ After the measurement has been completed, the measured
value will be displayed.
Parameter display can be switched.
TIP
• If the auto-run function of the detector has been set to
ON, the detector automatically returns to the
measurement starting position. If the auto-return of the
detector has been set to OFF, it stops at the position
where the measurement was complete. For information
about setting the auto-return function, refer to "7.5.7
Setting the auto-return function" (page 7-55).
No. 99MBB765A
4-16
To Next Page
Loading...
