7. MODIFICATION OF THE MEASUREMENT CONDITIONS AND EVALUATING CONDITIONS
Out-Cutoff Setup screen
6 Touch a place to set the ruler 2.
To adjust the ruler position, touch
/ .
Out-Cutoff Setup screen
7 Touch [Range set].
¾ The part between rulers 1 and 2 of the evaluation profile turns
blue.
TIP
• To select multiple ranges, repeat steps 3 to 7 above.
• To change the range, touch the red part. When the
ruler is displayed, repeat steps 4 to 7 above.
• To cancel the selected range, touch
[Cancel All].
• To cancel a part of the selected range, touch the blue
part of the waveform, and then, touch
[Cancel
Part] while the ruler is displayed.
Out-Cutoff Setup screen
8 Touch [Close].
¾ “Out-Cutoff” is displayed for “Del. Wave” on the Evaluating
Condition Menu screen.
Home screen
¾ When [RE-CAL.] is touched, “C” is displayed at the
beginning of the calculated results on the Home screen.
No. 99MBB765A
7-35
To Next Page
Loading...
